Honda Accord 2008 Manual page 61

07/11/02 09:04:52 61TA0000_040_0015
Starting System
Starter Overhaul (cont'd)
Armature Inspection and Test
1. Remove the starter (see page 4-11).
2. Disassemble the starter as shown at the beginning
of this procedure.
3. Inspect the armature for wear or damage from
contact with the permanent magnet. If there is wear
or damage, replace the armature.
＊０２
4. Check the commutator (A) surface. If the surface is
dirty or burnt, resurface it with an emery cloth or a
lathe to the specifications in step 5, or recondition
with
＊０３
4-14
＃ ＃
500 or 600 sandpaper (B).
A
5. Check the commutator diameter. If the diameter is
below the service limit, replace the armature.
Commutator Diameter
Standard (New): 28.0 28.1 mm (1.102 1.106 in.)
Service Limit:
6. Measure the commutator (A) runout.
• If the commutator runout is within the service
limit, check the commutator for carbon dust or
brass chips between the segments.
• If the commutator runout is not within the service
limit, replace the armature.
Commutator Runout
Standard (New): 0.02 mm (0.001 in.) max.
Service Limit:
A
B
− −
27.5 mm (1.083 in.)
0.05 mm (0.002 in.)
＊０４
＊０５