Transfer Shaft Disassembly/Reassembly; Transfer Cover A Bearing Outer Race Replacement - Honda CR-V 1997 Service Manual

Transfer Assembly
Transfer Shaft Disassemblyl
Reassembly
1. Support the transfer driven gear on steel blocks,
then press the transfer shaft out of damper hub.
PRESS
TRANSFER
Transfer Cover A Bearing Outer
Race Replacement
NOTE: Coat all parts with MTF during reassembly.
1. Re move the tapered roller bearing outer race from
transfer cover A by heati ng the cover to almost
212°F ( 100"CI using a hea t gun. Do not heat the
cover over 212°F (100°C),
I
SHAFT HEAT GUN
DAMPER
HUB
u
TRANSFER
DRIVEN
GEAR
2. Align the damper hub grooves and transfer driven
gear teeth. and reassemble the damper hub, needle
bearing, and transfer driven gear.
3. Install the transfer shaft using a press.
PRESS
tL
TRANSFER
~/SHAFT
qy
13-50
TRANSFER COVER A
BEARING OUTER RACE
2. Install the 68 mm thrust shim in transfer cover A.
PRESS
DRIVER
07749 - 0010000
ATTACHMENT.
62 x68 mm
07746 - 0010500
3. Install the tapered roller bearing outer ra ce using
the special too ts and a press.