Table of Contents
Advertisement
Tags
Purpose
To provide a list of all the tag numbers used together with a description of each of the machine
modifications.
Description
Each modification to the system is assigned a unique tag number. This section of the service
documentation contains a listing and brief description of all change tags. It also references the
diagnostic routine, dC111 Tag Matrix, used to access, enter, store and retrieve hardware and
software upgrade information contained in the machine's NVM.
Change tags listed in this section are listed by machine module. The module to which the tag
relates is identified by the tag prefix letter, for example; Tag F048 applies to the Finisher - mod-
ule. The module prefixes are:
•
Processor module - 001 to 250 (no prefix).
•
DADH module - D001 to D050.
•
Finisher (1K LCSS) module - L001 to L050.
•
Finisher (2K LCSS) module - F001 to F050.
•
Finisher (HCSS) module - H001 to H050.
•
Finisher (HCSS BM) module - B001 to B050.
•
Finisher (HVF) module - V001 to V050.
•
Network controller - N001 to N050
•
Fax - X001 to X050.
Tag Information
Information that may be included with each tag item is as follows:
•
Tag - gives the control number for the tag.
•
Class - gives the classification codes as listed in Table 1.
•
Use - indicates the multinational operating markets affected by the modification.
•
Manufacturing Serial Number - gives the serial number of the factory built machines with
the modification installed.
•
Purpose - gives a brief description of the modification.
•
Name - gives the name of the part or modification.
•
Kit Number - gives the part number of the kit or part required to install the modification.
•
Reference or Parts List On - indicates the parts list where the kit or modification part can
be found.
Mod / Tag Plate Location
The Processor module. Open the front door and the Mod / Tag plate is located on the left side
of the main machine frame.
The DADH module.
Lift up the DADH and the Mod / Tag plate is located on the rear of the
DADH.
The 1K LSCSS module. Un-dock the 1K LCSS and the Mod / Tag plate is located on the dock-
ing plate.
WorkCentre 5687 Family
The 2K LCSS module. Un-dock the LCSS and the Mod / Tag plate is located in the base pan of
the LCSS.
The HCSS module. Un-dock the HCSS and the Mod / Tag plate is located on the metal panel
under the docking latch.
The HCSSBM module. Un-dock the HCSSBM and the Mod / Tag plate is located on the metal
panel under the docking latch.
The HVF module. Un-dock the HVF and the Mod / Tag plate is located on the metal panel
under the docking latch.
The Network controller. Remove the network controller from the machine and the Mod / Tag
plate is located on the front cage, PL 16.10 Item 6.
Embedded Fax. The Mod / Tag plate is located on the safety cover, PL 20.10 Item 1.
Classification Codes
The Class or Classification code can be explained as follows:
Table 1 Classification codes
NASG
XE
code
code Description
-
1
Safety: Install this tag immediately.
M
2
Mandatory: Install this tag at the next opportunity.
R
3
Repair: Install this tag as a repair, at the failure of a component.
O
4
Optional: Install as a customer option or a field engineering decision.
S
4
Situational: Install as the situation demands.
N
5
Manufacturing: Cannot be installed in the field.
6
Refurbishing only.
August 2007
6-333
General Procedures & Information
Tags
Hide quick links:
Advertisement
Chapters
Table of Contents
