Xerox WorkCentre 5687 Series Service Manual page 2213

c. Select Image Output Terminal Registration Side 2 and repeat the above procedure
as necessary.
d. If Tray 5 is still out of specification, go to ADJ 7.3 and then ADJ 7.4. After checking
these adjustments, repeat the procedure in step 9.
10. Make copies of the test pattern 82E2010 or 82E2020 from the DADH and document glass
to check for skew. Refer to IQS 5 Skew. Use internal test prints 16 or 17 to check printer
skew. Refer to IQS 5 Skew.
11. Save the new settings to the machine resident diskette, GP 5.
Figure 1 Registration test pattern
WorkCentre 5687 Family
Top edge registration on the 20mm line
Figure 2 IOT registration
August 2007
6-321
Lead edge registration on the 20mm line
General Procedures & Information
dC604