Subaru IMPREZA GD 2007 Series Manual page 1923

asieps_tobira_IM_US.book 132 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Trouble Code (DTC) Detecting Criteria
GENERAL DESCRIPTION
0.04-inch Diagnosis
OK
Mode
Z
Mode
NG
Extend
Mode
Mode Z
(Purge control solenoid valve open-
ing failure diagnosis)
Mode A
(Estimated evaporation amount)
Mode B
(Sealed negative pressure, large
leakage judgment)
Mode C
(Pressure increase check,
advanced OK judgment)
Mode D
(Negative pressure variation mea-
surement, evaporation leakage
diagnosis)
Purge control solenoid valve 2 stuck
close diagnosis
OK OK
Mode
Mode Mode
B
A
Large leakage judgement
Cancel
NG
Z
OK
Perform purge control solenoid valve opening failure diagnosis
from the size of tank pressure variation from diagnosis start.
Calculate the tank pressure change amount (P1).
Decrease the pressure in the tank to the target value by introduc-
ing the intake manifold pressure to the fuel tank.
If the tank pressure cannot be reduced, it is diagnosed as large
leak.
Wait until the tank pressure returns to the target (start level of P2
calculation). If the tank pressure does not become the value,
make advanced OK judgment.
Calculate the tank pressure variation (P2), and obtain the diag-
nostic value using P1 found in Mode A.
Perform the evaporation diagnosis using the diagnostic value.
Perform purge control solenoid valve 2 stuck close diagnosis
using the variation gap between the tank pressure at the end of
mode C and after mode C.
GD(H4DOTC)-132
OK OK
Mode
C D
NG
Purge control
NG
solenoid valve 2
blockage diagnosis
Early OK
Mode Description
END
EN-05367
Diagnosis Period
3 — 16 seconds
10 seconds
5 — 25 seconds
1 — 15 seconds
10 seconds
3 seconds