Subaru Legacy 2003 Service Manual page 2763

DRIVE SHAFT SYSTEM
11) Install snap ring to shaft.
CAUTION:
Confirm that the snap ring is completely fitted
in the shaft groove.
12) Fill 100 to 110 g (3.53 to 3.88 oz) of specified
grease into the interior of SFJ outer race.
13) Apply a coat of specified grease to free ring and
trunnion.
14) Align alignment marks on free ring and trunnion
and install free ring.
CAUTION:
Be careful with the free ring position.
15) Align alignment marks on shaft and outer race,
and install outer race.
16) Install circlip in the groove on SFJ outer race.
CAUTION:
Pull the shaft lightly and assure that the circlip
is completely fitted in the groove.
17) Apply an even coat of the specified grease 30
to 40 g (1.06 to 1.41 oz) to the entire inner surface
of boot.
FRONT DRIVE SHAFT
18) Install SFJ boot taking care not to twist it.
CAUTION:
• The inside of the larger end of SFJ boot and
the boot groove shall be cleaned so as to be
free from grease and other substances.
• When installing SFJ boot, position outer race
of SFJ at center of its travel.
19) Put a band through the clip and wind twice in
alignment with band groove of boot.
CAUTION:
Use a new band.
20) Pinch the end of band with pliers. Hold the clip
and tighten securely.
NOTE:
When tightening boot, exercise care so that the air
within the boot is appropriate.
21) Tighten band by using ST.
ST 925091000
NOTE:
Tighten band until it cannot be moved by hand.
22) Tap on the clip with the punch provided at the
DS-00109
end of ST.
ST 925091000
CAUTION:
Tap to an extent that the boot underneath is not
damaged.
DS-00158
DS-32
BAND TIGHTENING TOOL
DS-00132
BAND TIGHTENING TOOL
DS-00133