Subaru Legacy 2003 Service Manual page 2757

DRIVE SHAFT SYSTEM
2) Using ST and a puller (common hand tool), re-
move bearing inner race.
ST1 399520105 SEAT
ST2 927080000 HUB STAND
CAUTION:
• Do not remove hub unit bearing unless dam-
aged.
• Do not re-use hub unit bearing after removal.
3) Using ST, press hub bolt out.
ST 927080000 HUB STAND
CAUTION:
Be careful not to hammer hub bolts. This may
deform hub.
HUB UNIT BEARING
D: ASSEMBLY
1) Using ST, press new hub bolt into place.
CAUTION:
• Ensure hub bolt closely contacts hub.
• Use a 12 mm (0.47 in) hole in the ST to pre-
vent hub bolt from tilting during installation.
ST 927080000
ST1
2) Using ST1, ST2 and ST3, press hub unit bearing
into hub.
ST1 927080000
ST2 927450000
ST2
ST3 28499AE000 SPACER
DS-00155
ST
DS-00054
CAUTION:
• Always press inner race when installing hub
unit bearing.
• Use a new hub unit bearing.
DS-26
HUB STAND
ST
DS-00055
HUB STAND
HUB INSTALLER
ST2
ST3
ST1
DS-00156