Subaru Legacy 2003 Service Manual page 2689

DIFFERENTIALS
6) Insert spacer, then press-fit pilot bearing with
ST1 and ST2.
ST1 399780104 WEIGHT
ST2 899580100 INSTALLER
ST2
ST1
7) Fit a new oil seal with ST.
NOTE:
• Press-fit until end of oil seal is 1 mm (0.04 in) in-
ward from end of carrier.
• Apply grease between the oil seal lips.
ST 498447120 OIL SEAL INSTALLER
ST
8) Press-fit companion flange with ST1 and ST2.
NOTE:
Be careful not to damage bearing.
ST1 899874100 INSTALLER
ST2 399780104 WEIGHT
ST1
ST2
REAR DIFFERENTIAL FOR T-TYPE
DI-00088
DI-00089
DI-00090
DI-34
9) Install new self-locking nut, fix companion flange
with ST and then tighten.
ST 498427200 FLANGE WRENCH
Tightening torque:
181 N·m (18.5 kgf-m, 134 ft-lb)
10) Assembling differential case (Without LSD)
Install side gears and pinion mate gears, with their
thrust washers and pinion mate shaft, into differen-
tial case.
NOTE:
• Apply gear oil on both sides of the washer and on
the side gear shaft before installing.
• Insert the pinion mate shaft into the differential
case by aligning the lock pin holes.
ST
DI-00091
DI-00239