Subaru Legacy 2003 Service Manual page 2681

DIFFERENTIALS
3) Install ST to rear differential.
ST 28099PA090 OIL SEAL PROTECTOR
4) Insert the spline shaft until the spline portion is
inside the side oil seal.
5) Remove ST from rear differential.
ST 28099PA090 OIL SEAL PROTECTOR
6) Completely insert axle shaft into rear differential
by pressing rear differential.
7) Adjust transmission jack as required so rear dif-
ferential stud bolt is properly inserted into rear
crossmember bushing.
REAR DIFFERENTIAL FOR T-TYPE
ST
DI-00279
DI-00280
DI-00281
DI-00282
DI-26
8) After rear differential stud bolt has been inserted
into rear crossmember bushing, raise transmission
jack to make jack rear differential level.
9) Temporarily tighten rear crossmember self-lock-
ing nuts.
10) Remove band from rear differential. Raise rear
differential just enough to move transmission jack
away from it.
11) Install rear differential front member.
Tightening torque:
T1: 65 N·m (6.6 kgf-m, 48 ft-lb)
T2: 110 N·m (11.2 kgf-m, 81 ft-lb)
T1
DI-00283
DI-00269
T2
DI-00284