Subaru Legacy 2003 Service Manual page 2781

ABS
4. Front ABS Sensor
A: REMOVAL
1) Disconnect battery ground cable.
2) Disconnect front ABS sensor connector located
next to front strut mounting house in engine com-
partment.
3) Remove bolts which secure sensor harness to
strut.
4) Remove bolts which secure sensor harness to
body.
(1) To front ABS sensor connector
(2) Bracket
5) Remove bolts which secure front ABS sensor to
housing, and remove front ABS sensor.
CAUTION:
• Be careful not to damage pole piece located
at tip of the sensor and teeth faces during re-
moval.
• Do not pull sensor harness during removal.
FRONT ABS SENSOR
ABS00140
( 1 )
( 2 )
ABS00141
ABS00142
B: INSTALLATION
1) Temporarily install front ABS sensor on housing.
CAUTION:
Be careful not to strike ABS sensor's pole piece
and tone wheel's teeth against adjacent metal
parts during installation.
2) Install front ABS sensor on strut and wheel
apron bracket.
Tightening torque:
33 N·m (3.3 kgf-m, 24 ft-lb)
(1) To front ABS sensor connector
(2) Bracket
ABS-12
ABS00142
( 1 )
( 2 )
ABS00141