Subaru Legacy 2003 Service Manual page 2767

DRIVE SHAFT SYSTEM
D: ASSEMBLY
CAUTION:
Use specified grease.
BJ side:
Molylex No. 2 (Part No. 723223010)
DOJ side:
VU-3A702 (Yellow) (Part No. 23223GA050)
1) Install BJ boot in specified position, and fill it with
60 to 70 g (2.12 to 2.47 oz) of specified grease.
2) Place DOJ boot at the center of shaft.
CAUTION:
Be sure to wrap shaft splines with vinyl tape to
prevent boot from scratches.
3) Insert DOJ cage onto shaft.
NOTE:
Insert the cage with the cut-out portion facing the
shaft end, since the cage has an orientation.
( A )
( B )
(A) Cage
(B) Cut-out portion
4) Install DOJ inner race on shaft and fit snap ring
with pliers.
NOTE:
Confirm that the snap ring is completely fitted in the
shaft groove.
REAR DRIVE SHAFT
5) Install cage, which was previously fitted, to inner
race fixed upon shaft.
NOTE:
Fit the cage with the protruded part aligned with the
track on the inner race and then turn by a half pitch.
6) Fill 80 to 90 g (2.82 to 3.17 oz) of specified
grease into the interior of DOJ outer race.
7) Apply a coat of specified grease to the cage
pocket and six balls.
8) Insert six balls into the cage pocket.
9) Align the outer race track and ball positions and
place in the part where shaft, inner race, cage and
balls are previously installed, and then fit outer
race.
DS-00127
DS-00128
DS-36
( A )
(A) Inner race
(B) Cage
( A )
(A) Outer race
(B) Grease
( B )
DS-00129
( B )
DS-00126