Subaru Legacy 2003 Service Manual page 2753

DRIVE SHAFT SYSTEM
9) Apply sufficient grease to oil seal lip.
Specified grease
SHELL 6459N
CAUTION:
• If specified grease is not available, remove
bearing grease and apply Auto Rex A instead.
• Do not mix different types of grease.
10) Install disc cover to housing the three bolts.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
11) Attach hub to ST1 securely.
12) Clean dust or foreign particles from the pol-
ished surface of hub.
13) Using ST2, press bearing into hub by driving in-
ner race.
ST1 927080000 HUB STAND
ST2 927120000 HUB INSTALLER
FRONT AXLE
ST2
ST1
DS-00060
DS-22
E: INSPECTION
Check the removed parts for wear and damage. If
defective, replace with new ones.
CAUTION:
• If bearing is faulty, replace it as the bearing
set.
• Be sure to replace oil seal at every overhaul.
(A) Replace as a set.
( A )
DS-00146