Subaru Legacy 2003 Service Manual page 2749

DRIVE SHAFT SYSTEM
11) Remove bolt which secures sensor harness to
strut.
12) Remove transverse link ball joint from housing.
13) Remove SFJ from transmission spindle.
14) Remove front drive shaft assembly from hub. If
it is hard to remove, use STs.
ST1 926470000 AXLE SHAFT PULLER
ST2 927140000 PLATE
CAUTION:
• Be careful not to damage oil seal lip and tone
wheel when removing front drive shaft.
• When replacing front drive shaft, also replace
inner oil seal.
ST1
FRONT AXLE
15) After scribing an alignment mark on camber ad-
justing bolt head, remove bolts which connect
housing and strut, and disconnect housing from
strut.
DS-00144
B: INSTALLATION
1) While aligning alignment mark on camber ad-
justing bolt head, connect housing and strut.
CAUTION:
Use a new self-locking nut.
Tightening torque:
2) Install front drive shaft. <Ref. to DS-28, INSTAL-
DS-00045
LATION, Front Drive Shaft.>
3) Install transverse link ball joint to housing.
Tightening torque:
4) Install ABS sensor harness on strut.
5) Install ABS sensor on housing.
Tightening torque:
6) Install disc rotor on hub.
7) Install disc brake caliper on housing.
Tightening torque:
ST2
DS-00145
DS-18
177 N·m (18.0 kgf-m, 130 ft-lb)
49 N·m (5.0 kgf-m, 36 ft-lb)
32 N·m (3.3 kgf-m, 23.9 ft-lb)
78 N·m (8 kgf-m, 57.9 ft-lb)
DS-00046