Subaru Legacy 2003 Service Manual page 2755

DRIVE SHAFT SYSTEM
B: INSTALLATION
1) Align hub unit bearing with back plate at mount-
ing holes and install hub unit assembly and back
plate. Temporarily tighten axle nuts.
CAUTION:
Be careful not to damage tone wheel.
2) Tighten four bolts to back plate.
3) Remove axle nut.
4) Using ST1 and ST2, pull axle shaft into place.
ST1 922431000 AXLE SHAFT INSTALLER
ST2 927390000 ADAPTER
5) Temporarily tighten axle nuts.
6) Install disc rotor on hub.
HUB UNIT BEARING
DS-00151
DS-00149
ST
DS-00123
DS-24
7) Install disc brake caliper on back plate.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
8) Install rear ABS sensor and brake cable bracket.
9) Adjust parking brake lever stroke by turning ad-
juster. <Ref. to PB-6, ADJUSTMENT, Parking
Brake Lever.>
DS-00152
DS-00147