Subaru Legacy 2003 Service Manual page 2685

DIFFERENTIALS
17) Remove rear bearing cone from drive pinion by
supporting cone with ST.
NOTE:
Place the replacer so that its center-recessed side
faces the pinion gear.
ST 398517700 REPLACER
18) Remove front oil seal from differential carrier
using ST.
ST 398527700 PULLER ASSY
19) Remove pilot bearing together with front bear-
ing cone using ST.
ST 398467700 DRIFT
(A) Pinion bearing
(B) Front bearing
(C) Rear bearing cup
REAR DIFFERENTIAL FOR T-TYPE
ST
DI-00074
DI-00075
ST
( C ) ( B ) ( A )
DI-00076
20) When replacing bearings, tap front bearing cup
and rear bearing cup in this order out of case by us-
ing a brass bar.
( B )
(A) 2 cutouts along diagonal lines
(B) Tap alternately with brass bar.
D: ASSEMBLY
NOTE:
• Assemble in the reverse order of disassembling.
• Check and adjust each part during assembly.
• Keep the shims and washers in order, so that
they are not misinstalled.
• Thoroughly clean the surfaces on which the
shims, washers and bearings are to be installed.
• Apply gear oil when installing the bearings and
thrust washers.
• Be careful not to mix up the right and left hand
races of the bearings.
• Replace the oil seal with new one at every disas-
sembly. Apply chassis grease between the lips
when installing the oil seal.
• Use new O-rings and gaskets.
DI-30
( A )
DI-00077
DI-00078