Subaru Legacy 2003 Service Manual page 2764

FRONT DRIVE SHAFT
DRIVE SHAFT SYSTEM
23) Cut off band with an allowance of about 10 mm
(0.39 in) left from the clip and bend this allowance
over the clip.
CAUTION:
Be careful so that the end of the band is in close
contact with clip.
24) Fix up boot on BJ in the same manner.
NOTE:
Extend and retract SFJ to provide equal grease
coating.
E: INSPECTION
Check the removed parts for damage, wear, corro-
sion etc. If faulty, repair or replace.
1) DOJ (Double Offset Joint)
Check seizure, corrosion, damage, wear and ex-
cessive play.
2) SFJ (Shudder-less Free-ring tripod Joint)
Check seizure, corrosion, damage and excessive
play.
3) Shaft
Check excessive bending, twisting, damage and
wear.
4) BJ (Bell Joint)
Check seizure, corrosion, damage and excessive
play.
5) Boot
Check for wear, warping, breakage or scratches.
6) Grease
Check for discoloration or fluidity.
DS-33