Subaru Legacy 2003 Service Manual page 2707

DIFFERENTIALS
(4) After driving in pinion shaft lock pin, stake
the both sides of the hole to prevent pin from fall-
ing off.
(5) Install crown gear on differential case.
NOTE:
• Before installing bolts, apply Lock Tite to bolt
threads.
Lock Tite
THREE BOND 1324 (Part No.: 004403042)
or equivalent
• Tighten diagonally while tapping the bolt heads.
Tightening torque:
62 N·m (6.3 kgf-m, 45.6 ft-lb)
11) Press side bearing cone onto differential case
with ST.
ST 498485400 DRIFT
ST
12) Assemble holders.
(1) Install oil seal into right and left holders.
ST 498447100 AXLE SHAFT OIL SEAL IN-
STALLER
ST
REAR DIFFERENTIAL FOR VA-TYPE
DI-00068
DI-00095
DI-00166
DI-52
(2) Install bearing race into right and left hold-
ers.
ST 398477702 BEARING OUTER RACE
DRIFT
ST
(3) Install the differential case assembly into dif-
ferential carrier in the reverse order of disas-
sembly.
(4) Lightly screw-in side holders of RH an LH
into differential carrier and install.
13) Perform adjustment of backlash of pinion
crown gear set and adjustment of preload of differ-
ential side bearing.
(1) Turn drive pinion with ST for better fitting of
differential side bearing.
ST 498427200 FLANGE WRENCH
DI-00167
DI-00134
ST
DI-00169