Result
Following the test phase, the result is displayed.
The value for the distance has a tolerance of +/- 1 m.
12.1.6
Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
Privileged EXEC mode.
12.1.6.1
add log
Description
With this command, you create an entry in the log.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call the command without parameters:
add log <log-entry>
The parameter has the following meaning:
Parameter
log-entry
Result
The entry has been made in the logbook.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
events
Description
Entry in the logbook
12.1 Event and fault handling
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Range of values / note
max. 150 characters
Diagnostics
893