Roxflash; Clear-All-Alarms; Acknowledge-All-Alarms - Siemens RX1400 Reference Manual

RUGGEDCOM NETCONF
Reference Guide
Section 6.1.5

roxflash

This action flashes a RUGGEDCOM ROX II image to the alternate partition. On rebooting, the device boots from the
flashed partition. Configurations are not transferred. This action takes a single parameter: {url}.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">
<rox-imaging>
<roxflash>
<url>{url}</url>
</roxflash>
</rox-imaging>
</admin>
</data>
</action>
</rpc>]]>]]>
NOTE
To determine which file transfer protocol is supported, refer to the RUGGEDCOM ROX II User Guide for
the device.
• {url}
The URL of the RUGGEDCOM NETCONF image to download. The URL format is protocol://
user:password@host:port/path-to-file. If the server does not require authentication,
user:password can be omitted. When using the default port for the protocol, :port may also be omitted.
Section 6.1.6

clear-all-alarms

This action clears all clearable alarms in the active list. Note that not all alarms can be cleared. This action does not
take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">
<clear-all-alarms/>
</admin>
</data>
</action>
</rpc>]]>]]>
Section 6.1.7

acknowledge-all-alarms

This action acknowledges all alarms in the active list. The alarms remain in the active list, but Alarm LED and
critical alarm relay are shut off. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
roxflash
Chapter 6
RUGGEDCOM ROX II Actions
57