Snmp-Discover; Launch-Upgrade - Siemens RX1400 Reference Manual

RUGGEDCOM NETCONF
Reference Guide
• Section 6.1.11, "restore-factory-defaults"
• Section 6.1.12, "delete-logs"
• Section 6.1.13, "install-files"
• Section 6.1.14, "backup-files (Backup Files)"
• Section 6.1.15, "full-configuration-save"
• Section 6.1.16, "full-configuration-load"
Section 6.1.1

snmp-discover

This action discovers the SNMP engine ID for a given IP address and port. Parameters include the {ip address},
{port}, and {trap-port}.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">
<snmp>
<snmp-discover>
<address>{ipAaddress}</address>
<port>{port}</port>
<trap-port>{trapPort}</trap-port>
</snmp-discover>
</snmp>
</admin>
</data>
</action>
</rpc>]]>]]>
• {ipAddress}
The SNMP IP address the device listens on.
• {port}
The SNMP data port the device listens on (if any).
• {trapPort}
The SNMP trap port the device listens on (if any).
Section 6.1.2

launch-upgrade

This action launches a RUGGEDCOM ROX II software upgrade to the alternate partition on the device. The
repository address and target release must be configured in admin/software-upgrade/upgrade-settings.
A reboot is required to run the new software release in the alternate partition. All configurations are locked from
the start of the upgrade to the subsequent reboot.
This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">
snmp-discover
Chapter 6
RUGGEDCOM ROX II Actions
55