Configuring The Ip Address And Default Gateway Address - Huawei AR1200 Series Usage Manual

Huawei AR1200&2200&3200 Series Enterprise Routers
SAE Card Usage Guide
7.1 Configuring the IP Address and Default Gateway
Address
This section describes how to configure the IP address and default gateway address of interface
GE0 or GE1 for the SAE board that run Windows Server 2008 R2.
Pre-configuration Tasks
l
l
Procedure
Step 1 Power on the SAE board and enter the Windows Server 2008 R2 operating system. Connect a
network cable to interface GE0 or GE1.
Step 2 Choose Start > Control Panel > Network and Internet > Network and Sharing Center. Click
Local Area Connection that corresponds to interface GE0 or GE1, and click Properties.
Figure 7-1 Network and Sharing Center
Step 3 Choose Internet Protocol Version 4(TCP/IPv4) and click Properties.
Issue 02 (2012-08-30)
Installing the operating system and drivers on the SAE board.
Planning the IP address, subnet mask, and default gateway address of interface GE0 or
GE1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Managing the SAE Board
37