Configuring Mpls-Tp Oam On An L2+L3 Network; Before You Start - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
11
12
13
14
15
16
17
18
19
20
The Max delay:4294847296
The Min delay:4294827296
The delay average:4294842296
The total number of the record is: 20
Run the display mpls-tp oam meg meg-name statistic-type command to view dual-ended
packet loss statistics obtained using MPLS-TP OAM.
<HUAWEI> display mpls-tp oam meg test statistic-type lost-measure dual-ended
Dual-end loss measurement statistics:
Index Near-end lost frames Loss ratio Far-end lost frames Loss ratio
1
Max near-end lost frames:10,frame loss ratio:12.50%
Min near-end lost frames:10,frame loss ratio:12.50%
Average near-end lost frames:10,frame loss ratio:12.50%
Max far-end lost frames:10,frame loss ratio:12.50%
Min far-end lost frames:10,frame loss ratio:12.50%
Average far-end lost frames:10,frame loss ratio:12.50%

9.5 Configuring MPLS-TP OAM on an L2+L3 Network

The NE80E/40E can use MPLS-TP OAM to monitor an L2+L3 IP network.

9.5.1 Before You Start

MPLS-TP OAM can be configured to monitor L2+L3 networks.
Usage Scenario
MPLS-TP OAM can detect faults on L2+L3 IP networks and collect performance statistics. On
the network shown in
static PWs on an L2VPN, and services between NPE1 and PE1 are transmitted through an
L3VPN. A VE-Group is created on NPE1 to terminate the L2VPN and access the L3VPN. UPE1
and PE1 are MEPs, and NPE1 is a MIP. MPLS-TP OAM runs on UPE1 and PE1, providing the
functions listed in
Issue 02 (2014-09-30)
4294847296 0
4294847296 0
4294847296 0
4294827296 20000
4294827296 0
4294847296 20000
4294847296 0
4294847296 0
4294847296 0
4294847296 0
10
Figure
Table 9-11.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
The Max delay variation:20000
The Min delay variation:0
The delay variation average:7368
12.50% 10
9-6, services between UPE1 and NPE1 are transmitted through
9 MPLS-TP OAM Configuration
12.50%
951