Configuring Parameters For Communication Between The Ac And Aps - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Step 5 (Optional) Configure the AC as a DHCP server to allocate IP addresses to APs.
1.
2.
3.
4.
An AP can set up a connection with an AC only after obtaining an IP address from the AC, a
broadband remote access server (BRAS), or a DHCP server. When the AC is configured as a
DHCP server, it can allocate IP addresses to APs.
Step 6 Run:
wlan
The WLAN view is displayed.
Step 7 Run:
wlan ac source interface { LoopBack loopback-num | Vlanif
The source interface of the AC is configured.
The AC uses the IP address of the specified source interface as the source IP address. All APs
connected to the AC can learn this IP address.
----End
Result
Run the display wlan ac-global command. The AC configuration will be displayed.
5.1.4 Configuring Parameters for Communication Between the AC
and APs
Before configuring WLAN services on an AC, ensure that the AC can communicate with APs.
To enable an AP to go online, manually add the AP to the AC or configure the AC to discover
APs and configure a whitelist. If the AP is in the whitelist, it can go online immediately after
the AC discovers it. If the AP is not in the white list, confirm the AP identity and enable the AP
to go online.
Establishing the Configuration Task
Before configuring parameters for communication between an AC and APs, familiarize yourself
with the applicable environment, complete the pre-configuration tasks, and obtain the data
Issue 01 (2011-07-15)
Run:
dhcp enable
DHCP is enabled on the VLANIF interface.
Run:
interface vlanif vlan-id
A VLANIF interface is created.
Run:
ip address
An IP address range is configured for APs.
Run:
quit
Return to the system view.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 WLAN Configuration
vlanif-id }
152