Configuring The Ftp Upload Test Parameters - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
l
Data Preparation
To configure the FTP upload test, you need the following data.
No.
1
2
3
4
5
6

6.5.2 Configuring the FTP Upload Test Parameters

This part describes how to set parameters for the FTP upload test.
Context
Do as follows on the NQA client (FTP client):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type ftp
The test type is set to FTP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters for the FTP upload
test ( For detailed parameter configurations, see the chapter
Parameters
l To configure the source IP address, run the source-address ipv4 ip-address command.
Issue 02 (2012-03-30)
Configuring routes between the NQA client and the FTP server
Data
Administrator name and test name
IP address of the FTP server
FTP user name and password
(Optional) Source IP address of the FTP operation and VPN instance name and source
and destination port numbers of the FTP operation
Name or size of the uploaded file
Start mode and end mode of the test
):
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
Configuring Universal NQA Test
152