Configuring The Eventtable - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Do as follows on the router on which traffic statistics should be collected:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface ethernet interface-number
The interface view is displayed.
Step 3 Run:
rmon history entry-number buckets number interval sampling-interval [ owner owner-
name ]
The historyControlTable is configured.
----End

2.2.5 Configuring the EventTable

After EventTable is configured, when the number of events exceeds the alarm threshold, the
router generates logs, sends traps, or generates logs and sends traps.
Context
Do as follows on the router that is monitored:
The RMON event management module is responsible for adding events to the corresponding
rows in the eventTable and defining the methods of processing events:
l
l
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
rmon event entry-number [ description string ] { log | trap object | log-trap
object | none } [ owner owner-name ]
The eventTable is configured.
----End
Issue 02 (2012-03-30)
NOTE
To reduce the effect on the performance of the system, the sampling interval of the history table should be
longer than 10 seconds, and the same port should not be configured with too many history control entries
and alarm entries.
log: sending only logs
log-trap: sending both logs and trap messages to the NM Station
none: marking that no event occurs
trap: sending trap messages to the NM Station
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 RMON Configuration
48