Connecting To X-Tio Module - Mitsubishi Electric GT16 User Manual

53.5.15 Connecting to X-TIO Module


Communication settings
Make the communication settings of the temperature
controller.
Item
*1
9600bps, 19200bps, 38400bps
Communication speed
Communication protocol MODBUS
Data bit: 8bit, Parity: None
Data bit: 8bit, Parity: Even
Data bit configuration
Data bit: 8bit, Parity: Odd
Stop bit: 1bit (fixed)
*2
1 to 99
Module address
When combining the module, turn ON the
Internal data bus
internal data bus terminating resistor at both
terminating resistor
ends of the module.
Data interval extension
0 to 99ms
time
*1 Adjust the settings with GOT settings.
*2 When the setting value is set to 0, a communication is not
made.

Setting DIP switches
Make the settings of transmission speed, data bit
configuration, communication protocol.
Setting item Set value
9600bps ON OFF
Communication
19200bps OFF ON
speed
38400bps ON
Data bit: 8bit,
Parity: None
Data bit Data bit: 8bit,
configuration Parity: Even
Data bit: 8bit,
Parity: Odd
Communication
MODBUS
protocol
Internal data OFF
bus
termination
ON
resistor setting
Data interval
0 to 99ms
extension time
53 - 22
53. CONNECTION TO RKC TEMPERATURE CONTROLLER
53.5 Temperature Controller Side Setting
Setting range
Dip switch
ON
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
Switch position
1 2 3 4 5 6
ON
ON OFF OFF
ON OFF ON
ON ON ON
ON
ON OFF ON

Module address settings
Set the unit address using the rotary switch (address
setting switch).

Data interval extension time settings
Set the data interval extension time as the following
procedure.
1.
Turn the power of the module OFF.
2.
Set the DIP switch 4 and 6 to "ON" and 5 to "OFF".
3.
Set the data interval extension time using the rotary
switch (unit address setting switch).
The setting method is the same as that of the module
address.
4.
ON Turn the power of the module ON.
The FAIL/RUN lamp lights in green and the set time
OFF
becomes valid.
5.
Turn the power of the module OFF again and set the
DIP switches and rotary switch to the original position.
7 8
OFF
ON
Rotary switch
(Address setting switch)
FAIL/RUN
RX/TX Upper digit setting
EVENT1
EVENT2
EVENT3
(Set value x10)
EVTNT4
Lower digit setting
(Set value x1)