Connecting To H-Pcp-A, H-Pcp-B - Mitsubishi Electric GT16 User Manual

(2) Communication mode settings
(a) COM.PORT1/COM.PORT2
SW2
5 6 7 8
ON OFF OFF OFF
(b) COM.PORT3
SW3
5
ON
(3) Settings of data length, parity bit, and stop bit
(a) COM.PORT1/COM.PORT2
SW2
Data bit configuration
1 2
OFF OFF Data 8-bit, Non parity, Stop 1bit
(b) COM.PORT3
SW3
Data bit configuration
1 2
OFF OFF Data 8-bit, Non parity, Stop 1bit

Unit address settings
Set the unit address using the unit address setting
switch.
53 - 16
53. CONNECTION TO RKC TEMPERATURE CONTROLLER
53.5 Temperature Controller Side Setting
Communication protocol
MODBUS protocol
Communication protocol
MODBUS protocol
Unit address setting switch
Setting range: 0 to F
53.5.2 Connecting to H-PCP-A, H-
PCP-B

Communication settings
Make the communication settings of the temperature
controller.
Item
*1
9600bps, 19200bps
Transmission speed
Data bit 8bits
Parity bit None
*2
0 to F
Unit address
*1 Adjust the settings with GOT settings.
*2 Select the unit address without overlapping with that of other
units.

Setting DIP switches
Make the settings of transmission speed, data length,
parity bit, and stop bit.
Top section
Rear view of module mainframe with mother block removed
(1) Transmission speed settings
3 4
OFF ON
ON ON
(2) Settings of data length and parity bit
1 2
OFF OFF
Setting range
4 3
2 1
Communication speed
9600bps
19200bps
Data bit configuration
Data 8-bit, Non parity
OFF
ON