Operation Procedures From Display Of User-Created Monitor Screen To Start Of Ladder Monitoring - Mitsubishi Electric GOT-A900 Series Operating Manual

5. OPERATION PROCEDURES FOR THE LADDER MONITOR FUNCTION

5.2 Operation procedures from display of user-created monitor screen to start of ladder monitoring

This section shows the operation procedures for the GOT when starting each
operation of the ladder monitor function after the ladder monitor function system
program (OS) has been installed in the GOT built-in memory.
Start
The memory board applicable for the PLC
CPU at the monitoring destination is
installed on the GOT.
Start up GOT.
Display the user-created monitor screen.
Start the ladder monitor function.
1)
Display the PLC read screen.
Specify the PLC CPU for the ladder monitor
and the program to be read.
The PC program is read.
Display the ladder monitor screen.
Read the sequence program that is
displayed on the ladder monitor screen.
*1 With the drawing software, touch the key where the touch switch (expanded) function is set, and
start the circuit monitor function.
When the Utility screen is displayed, start the circuit monitor function by touching LADDER MON. .
!!! (∗1)
When not reading the
sequence program from
the PLC CPU
!!!
!!!
When you touch Mon. , the circuit monitor starts.
See Sec. 6.2
Touch PLCRD.
1)
Touch Menu
!!!
See Sec. 6.1.2
5 - 2
MELSEC
! When reading the sequence program from
the PLC CPU
!!!
See Sec. 6.1.1
GOT