No Authorized-Manager Ip-Source - Siemens SCALANCE XC-200 Configuration Manual

Security and authentication
11.3 Management Access Control List
Result
The interfaces and protocols via which an authorized manager is allowed to access the device
are configured.
Note
No restrictions for console port
The restrictions do not apply to the serial console (console port).
Further notes
You delete an interface for access of an authorized manager with the no authorized-
manager ip-source command.
You show the information about the configuration of the authorized managers with the show
authorized-manager command.
You change the mode with the base bridge-mode command.
11.3.2.4

no authorized-manager ip-source

Description
With this command, you delete an interface via which an authorized manager is allowed to
access the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no authorized-manager ip-source <ip-address>
The parameters have the following meaning:
Parameter
ip-address
subnet-mask
prefix-length
516
[{<subnet-mask>|/<prefix-length(0-32)>}]
Description
Specifies the network or the IP address
for which the IP manager is authorized
Subnet mask that restricts the authori‐
zation
Decimal representation of the mask as
a number of "1" bits
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Enter a valid IP address or a net‐
work
Enter a valid mask
0 ... 32
Configuration Manual, 07/2017, C79000-G8976-C361-06