Vrrp Primary-Ip - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRP
9.5.5.6

vrrp primary-ip

Description
With this command, you specify the primary IP address specified with the VRRP packets as
the source address.
Note
This command is available only with layer 3.
Requirement
● You are in the VRRP Interface Configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> primary-ip <ip_addr>
The parameters have the following meaning:
Parameter
vrid
ip_addr
Result
The primary IP address is specified.
Further notes
You configure a VRRP interface with the
You remove the primary IP address with the
You show the configuration of the virtual router with the
command.
444
Description
ID of the virtual router
Value for an IP address
interface
no vrrp pirmary-ip
Range of values
1 ... 255
specify a valid IP address
command.
command.
show vrrp interface - vrid
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07