Gvrp - Siemens SCALANCE XM-400 Configuration Manual

– F
– T
Steps in configuration
1. Enter an ID in the "VLAN ID" input box.
2. Click the "Create" button. A new entry is generated in the table. As default, the boxes have
"-" entered.
3. Enter a name for the VLAN under Name.
4. Switch the VLAN to the transparent or standard compliant mode.
5. Specify the use of the port in the VLAN. If, for example you select M, the port is a member
of the VLAN. The frame sent in this VLAN is forwarded with the corresponding VLAN tag.
6. Click the "Set Values" button.
5.5.4.2

GVRP

Configuration of GVRP functionality
Using GVRP frame, a different device can register at the port of the device for a specific VID.
A different device, can, for example be an end device or a switch. The device can also send
GVRP frames via this port.
On this page, you can enable each port for GVRP functionality.
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12
The port is not a member of the specified VLAN and it is not possible for the VLAN to
be registered dynamically at this port using GVRP. If a port in a VLAN has this option,
it cannot become a member of this VLAN even if it is configured as a trunk port.
You can configure further settings in "Layer 2 > VLAN > Port-based VLAN".
This option is only displayed and cannot be selected in the WBM.
This port is a trunk port making it a member in all VLANs.
You configure this function in the CLI (Command Line Interface) using the
"switchport mode trunk" command.
Configuring with Web Based Management
5.5 The "Layer 2" menu
259