Commands In The Interface Configuration Mode; Channel-Group - Siemens SCALANCE XC-200 Configuration Manual

Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show lacp [<port-channel(1-8)>]{counters|neighbor[detail]}
The parameters have the following meaning:
Parameter
port-channel
counters
neighbor
detail
If you do not select a port channel, information for all available interfaces is displayed.
Result
The information is displayed.
6.2.2

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
6.2.2.1

channel-group

Description
With this command, you add an interface to an Etherchannel.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Number of the Channel-Group
Shows the values of the counters
Displays information on neighbor ports
Displays detailed information on neigh‐
bor ports
Network structures
6.2 Link aggregation
Range of values / note
1 ... 8
-
-
-
215