Commands In The Interface Configuration Mode; Channel-Group - Siemens SCALANCE XM-400 Configuration Manual

6.2.5

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
● If you exit the Interface configuration mode with the
6.2.5.1

channel-group

Description
With this command, you add an interface to an Etherchannel.
Requirement
With the
logical interface for an Etherchannel.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
channel-group <channel-group-number(1-8)>mode{on|active|passive}
The parameters have the following meaning:
Parameter
channel-group-number
on
active
passive
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Global configuration mode.
Privileged EXEC mode.
interface po <channel-group-id(1-8)>
Description
Number of the channel-group
Adds the interface without LACP to a channel group.
This corresponds to manual bundling.
The negotiation of a connection via LACP is started
unconditionally
The negotiation of a connection via LACP is started
when an LACP packet arrives from the connection
partner
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
command, you have already generated a
Network structures
6.2 Link aggregation
Range of
values
1 ... 8
-
-
-
181