Reset Button - Siemens SIMATIC NET SCALANCE XR-300WG Operating Instructions Manual

4.5

RESET button

EXPLOSION HAZARD
Do not press the RESET button if there is a potentially explosive atmosphere.
Position
The "RESET" button is located on the front of the SCALANCE XR-300WG.
Figure 4-1
Resetting the device to factory defaults
NOTICE
Previous settings
If you reset, all the settings you have made will be overwritten by factory defaults.
NOTICE
Inadvertent reset
An inadvertent reset can cause disturbances and failures in the configured network.
Requirement
• The device is in operation.
• The function "Reset to factory defaults" is enabled for the RESET button.
Note
Reset despite disabled "RESET" button
If you have disabled the "Reset to Factory Defaults"function for the "RESET" button in the
configuration, this does not apply during the startup phase, see section "Restoring the
factory settings (Page 70)"
If the function has been disabled in the configuration, it is only disabled on completion of the
startup phase.
SCALANCE XR-300WG
Operating Instructions, 03/2021, C79000-G8976-C454-07
WARNING
Position of the "RESET" button on the SCALANCE XR-300WG
Description of the device
4.5 RESET button
29