15.4.9
BMU interrupts
Interrupt generation rules
•
Each interrupt source has a dedicated status bit that indicates if an interrupt has been
issued or not.
•
A status flag shall be cleared by software by writing a 1 to the corresponding bit
position.
•
If a status flag is set and a new hardware condition leading to an interrupt occurs, no
new interrupt is generated. If a software access to clear the interrupt status bit
takes place and in the same cycle the hardware wants to set the bit, the
hardware condition wins the arbitration.
User's Manual
BMU, V2.6
15-21
TC1728
Bus Monitor Unit (BMU)
V1.0, 2011-12