SSANGYONG Kyron Repair Manual page 432

46
4890
14. ESP SYSTEM AIR BLEEDING
The vehicle equipped only with ABS can use the conventional air bleeding procedure, however, the
vehicle equipped with ESP should use the oil supply device using a compressor inorder to bleed the air.
Air Bleeding Should Be Done When
1. After removal and installation of the brake master cylinder.
2. After removal and installation of the ABS HECU.
3. After removal and installation of the brake oil pipes and hoses.
4. After replacing the brake fluid.
Air Bleeding Procedures
1. Apply the parking brake and start the engine when the shift lever is at "P" position.
2. Connect the oil supply device (air bleeding device) with air compressor to brake reservoir. The oil supply device
should be filled with sufficient oil.
3. Loosen the air bleed screw in caliper and place an empty container under the screw.
4. Bleed the air in each wheel by using diagnostic device. At this time, the modulator motor runs for 180 seconds.
5. Simultaneously, run the oil supply device to supply oil and depress the brake pedal repeatedly.
This procedure needs at least 3 persons for doing below jobs:
1) Collect the bleeding oil into the container.
2) Depress the brake pedal repeatedly.
3) Check the conditions of oil supply device.
The air bleeding procedure should be started from the rear right wheel.
6. Repeat the step 4 through 5 until clear brake fluid comes out of air bleed screw.
7. Perform the same procedures at each wheel.
ABS/ESP SYSTEM
KYRON SM - 2005.09
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN