Wiper And Washer System - SSANGYONG Kyron Repair Manual

2
7810

WIPER AND WASHER SYSTEM

The wiper and washer system are controlled by STICS according to driver's wiper switch operation. And the
detection of rain drops by rain sensor is transmitted to STICS as the signal for wiper system control.
The characteristics of the wiper and washer system including basic functions of manual wiper are as follows.
1. Wiper function coupled auto washer
Rear wiper/washer
operation location
2. Integrated auto light sensor in rain sensor unit
Rain sensor
emitter lens
Light receiving
area of auto
light sensor
3. Rear washer fluid supply system
There is no separate washer fluid reservoir for the rear washer system in this vehicle. The rear washer system
uses the front washer fluid reservoir. Because of this, the washer hose is supposed to be long between front
reservoir tank and rear washer nozzle. To avoid being damaged or interfered while in assembling the vehicle,
the rear washer hose is fixed on headlining with silicone
WIPER & WASHER SYSTEM
KYRON SM - 2005.09
Auto washer operation
switch (press)
Rear washer hose and roof wiring harness are
fixed at the headlining section with silicone.
When the front wiper switch is off and this switch is
pressed, washer fluid will be sprayed and the wiper
will automatically operate 4 times. Then, the fluid will
be sprayed again and the wiper will automatically op-
erate 3 times.
The rain sensor unit is installed on a proper location
to detect the rain drops and the illumination intensity.
To control the system, the sensed values of rain sen-
sor and auto light sensor are sent to pin no. 63 in
STICS unit.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN