Power Seat - SSANGYONG Kyron Repair Manual

POWER SEAT

Seat Position Control
1. The position sensor senses the changes of motor in the seat.
2. The seat position is stored by the memory order of position switch.
3. The stored seat position is recalled by the recall order of position switch.
4. The manual adjustment of seat positions takes priority over the memory and recall orders.
Motor Drive Control
1. In the case of the automatic control, each motor drive is delayed for 100 msec to prevent the irruptive current from
being overlapped. The priorities are as follows.
Seat sliding → Seatback reclining → Seat cushion height adjusting (front) → Seat cushion height adjusting (rear)
ON
Seat sliding
relay
OFF
ON
Seatback
reclining relay
OFF
ON
Seat cushion
(front) adjusting
OFF
relay
Seat cushion
(rear) adjusting
relay
OFF
2. Continuous motor driving time
Seat sliding: 16 seconds, Seatback reclining: 50 seconds, Cushion height adjusting: 6 seconds
3. Reverse control
When reversing the control motor, the motor starts to rotate in the opposite direction 100 msec after the forward
driving is completed.
4. The motor doesn't operate if the difference between the stored position and the current position is out of the
specified range.
1) Sliding: 12 edges (6 pulses)
2) Cushion height: 6 edges (3 pulses)
3) Reclining: 100 mV
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Min 100 ms
Min 100 ms
Min 100 ms
11
7410
SEAT POSITION WITH MEMORY
KYRON SM - 2005.09