SSANGYONG Kyron Repair Manual page 949

Resetting of Sunroof Control Unit
If the sunroof does not operate properly, check and reset the sunroof control unit.
1. To prevent any parts damage and personal injury, the sunroof setting is canceled
1) When the battery voltage is disconnected, the fuse is blown, or the abrupt voltage drop occurs due to old
battery while operating the sunroof.
2) When an undesired cancellation occurs due to mistake by a technician.
3) When parts damage, shorted circuit, or electric leakage occurs.
4) When keeping the sunroof switch at "OPEN" position.
2. Symptoms when the sunroof setting is canceled
1) The one-touch operation cannot be activated.
2) The sunroof is tilted even after completion of closing operation when closing it.
3) The sunroof opening and tilting level is significantly low.
4) The sunroof does not operate properly when operating the sunroof switch.
3. [0] point reset of sunroof
1) Close the sunroof with the sunroof switch and keep the position for approx. 10 seconds. If the [0] point setting
is successfully completed, the sunroof should be properly opened from this position.
2) Check if the sunroof is fully closed. Tilt the sunroof with the sunroof switch and keep it at the position for 10
seconds ([0] point setting).
3) Close the sunroof with the sunroof switch.
4. Checking after reset
1) If the sunroof does not operate properly, check the power supply system.
2) If the sunroof does not operate or operates only during the switch operation even the power supply system is
in normal conditions, check if the ground circuit of switch is securely tightened and reset the sunroof system
again.
NOTE
• If the power supply system is in normal conditions, replace the sunroof motor or the sunroof control unit.
• Replace the sunroof control unit with new one and check if the sunroof operates properly before replacing
the sunroof motor.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
5
7340
SUNROOF SYSTEM
KYRON SM - 2005.09