Aggregate-Address - Dell Z9500 Reference Manual

ipv6 unicast
vrf vrf-name
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
6.5.1.0

aggregate-address

To minimize the number of entries in the routing table, summarize a range of prefixes.
Z9500
Syntax
aggregate-address ip-address mask [advertise-map map-name] [as-
set] [attribute-map map-name] [summary-only] [suppress-map map-
name]
Parameters
ip-address
mask
Border Gateway Protocol
NOTE: Use this attribute to start a BGP instance
corresponding to either a specific address family in a
default VRF or an IPv4 address family in a non-default
VRF.
Enter the keyword ipv6 followed by the keyword unicast
to enable BGPv6 mode.
(Optional) Enter the keyword vrf followed by the name of
the VRF to install the IPv6 route in that VRF.
NOTE: It will not be possible to enable VRF mode for
IPv6 unicast without configuring the corresponding IPv4
unicast mode for the same VRF. While deletion,
whenever the IPv4 VRF mode is deleted for the VRF, it
will automatically delete the IPv6 VRF configurations as
well.
Description
Added support for IPv6 VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the IP address and mask of the route to be the
aggregate address. Enter the IP address in dotted decimal
format (A.B.C.D) and mask in /prefix format (/x).
339