Router Bgp - Dell Z9500 Reference Manual

apply outbound to an EBGP peer/peer-group, the advertised routes corresponding
to those peer/peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any
other parameters, the system redistributes all OSPF internal routes, external type 1
routes, and external type 2 routes. RFC does not support this feature.

router bgp

To configure and enable BGP, enter ROUTER BGP mode.
Z9500
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number
Defaults Not enabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage At least one interface must be in Layer 3 mode for the router bgp command to
Information
be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
Example
Dell(conf)#router bgp 3
Dell(conf-router_bgp)#
420
Enter the AS number. The range is from 1 to 65535 (2 byte),
from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535
(dotted format).
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol