Aggregate-Address - Dell S4810 Reference Manual

Parameters
ipv4 multicast
ipv4 vrf vrf-
name
ipv6 unicast
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 6.5.1.0

aggregate-address

To minimize the number of entries in the routing table, summarize a range of prefixes.
S4810
Syntax
aggregate-address ip-address mask [advertise-map map-name] [as-
set] [attribute-map map-name] [summary-only] [suppress-map map-
name]
Parameters
ip-address
mask
378
Enter the keyword ipv4 followed by the keyword
multicast to enable BGPv4 multicast mode.
Enter the keyword ipv4 followed by the keyword vrf and
then the name of the VRF to enable VRF mode.
NOTE: Use this attribute to start a BGP instance
corresponding to either a specific address family in a
default VRF or an IPv4 address family in a non-default
VRF.
Enter the keyword ipv6 followed by the keyword unicast
to enable BGPv6 mode.
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the IP address and mask of the route to be the
aggregate address. Enter the IP address in dotted decimal
format (A.B.C.D) and mask in /prefix format (/x).
Border Gateway Protocol