Dell Z9500 Reference Manual page 58

1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree mstp command. The prompt changes to include (conf-
mstp).
You can return to CONFIGURATION mode by using the exit command.
Per-VLAN SPANNING TREE (PVST+) Plus Mode
To enable and configure the Per-VLAN Spanning Tree (PVST+) protocol, use PVST+ mode. For more
information, refer to Per-VLAN Spanning Tree Plus
NOTE: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.
To enter PVST+ mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree pvst command. The prompt changes to include (conf-
pvst).
You can return to CONFIGURATION mode by using the exit command.
PORT-CHANNEL FAILOVER-GROUP Mode
To configure shared LAG state tracking, use PORT-CHANNEL FAILOVER-GROUP mode. For more
information, refer to Port Channel
To enter PORT-CHANNEL FAILOVER-GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the port-channel failover-group command. The prompt changes to include (conf-po-
failover-grp).
You can return to CONFIGURATION mode by using the exit command.
PREFIX-LIST Mode
To configure a prefix list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip prefix-list command. Include a name for the prefix list. The prompt changes to
include (conf-nprefixl).
You can return to CONFIGURATION mode by using the exit command.
PRIORITY GROUP Mode
To create an ETS priority group, use PRIORITY GROUP mode.
To enter PRIORITY GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the priority-group command then the group name. The prompt changes to include (conf-
pg).
You can return to CONFIGURATION mode by using the exit command.
58
(PVST+).
Commands.
CLI Basics