Verify - Dell Z9500 Reference Manual

Usage
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI)
Information
must be enclosed in square brackets, [X:X:X:X::X]. For maximum flexibility this
command accepts IPv6 host addresses with or without the square brackets.
After you upgrade the system image, by entering the command. specify the
location where the Dell Networking OS image used to boot the system is stored
(boot system), save the configuration to the start-up config file (write memory),
and reload the system (reload).
Example
Dell# upgrade system tftp://10.11.8.12/dv-rainier-13 a:
00:39:32 : Discarded 1 pkts. Expected block num : 51. Received
block num: 50
!00:39:36 : Discarded 1 pkts. Expected block num : 65.
Received block num: 64
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!...................................................
...............................................................
...............................................................
.............!
93924044 bytes successfully copied
System image upgrade completed successfully.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!
Image upgraded to all

verify

Validate the software image on the flash drive after the image has been transferred to the system, but
before the image has been installed.
Syntax verify { md5 | sha256 }[ flash:// ] img-file [hash-value]
Parameters
md5
sha256
flash://
img-file
hash-value
84
Enter the md5 keyword to use the MD5 message-digest
algorithm.
Enter the sha256 keyword to use the SHA256 Secure Hash
Algorithm
(Optional). Enter the flash:// keyword. The default is to
use the flash drive. You can just enter the image file name.
Enter the name the Dell Networking software image file to
validate.
(Optional). Enter the relevant hash published on i-Support.
File Management