Interface Vlan - Dell Z9500 Reference Manual

interface vlan

Configure a VLAN. You can configure up to 4094 VLANs.
Z9500
Syntax
interface vlan vlan-id
Parameters
vlan-id
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command CONFIGURATION
Modes
Command
Version
History
9.2(1.0)
9.0(1.3)
Usage
For more information about VLANs and the commands to configure them, refer to
Information
the
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not
supported in VLANs. IP ACLs are supported. For more information, refer to the
Access Control Lists (ACL)
Example (Single
Dell(conf)#int vlan 3
Range)
Dell(conf-if-vl-3)#
Related
interface
Commands
interface loopback
interface null
interface port-channel
show vlan
shutdown
tagged
untagged
822
Enter a number as the VLAN Identifier. The range is 1 to
4094.
Description
Introduced on the Z9500.
Introduced on the S5000.
Virtual LAN (VLAN) Commands
chapter.
– configures a physical interface.
– configures a loopback interface.
– configures a null interface.
– configures a port channel group.
– displays the current VLAN configuration on the switch.
– disables/enables the VLAN.
– adds a Layer 2 interface to a VLAN as a tagged interface.
– adds a Layer 2 interface to a VLAN as an untagged interface.
section of the Layer 2 chapter.
Interfaces