Control And Monitoring; Asf-Mode - Dell Z9500 Reference Manual

Control and Monitoring

This chapter contains the commands to configure and monitor the system, including Telnet, file transfer
protocol (FTP), and trivial file transfer protocol (TFTP).
NOTE: This command replaces the enable optic-info-update interval command to
update information on temperature and power monitoring in the simple network management
protocol (SNMP) management information base (MIB).

asf-mode

Enable the transmission of Alternate Store and Forward (ASF) packets as soon as a threshold is reached.
Z9500
Syntax
asf-mode linecard {slot-id | all}
To return to standard Store and Forward mode, use the no asf-mode linecard
command.
Parameters
linecard slot-id
Defaults Not configured
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.0
8.3.7.0
86
Enter the slot ID of a Z9500 line card. The range of slot IDs is
from 0 to 2. Enter all to enable ASF mode on all line cards
on the switch.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
4
Control and Monitoring