Bgp Default Local-Preference - Dell Z9500 Reference Manual

reuse
suppress
max-suppress-
time
route-map
map-name
Defaults Disabled.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.4.1.0
Usage If you enter bgp dampening, the default values for half-life, reuse,
Information
suppress, and max-suppress-time are applied. The parameters are position-
dependent; therefore, if you configure one parameter, you must configure the
parameters in the order they appear in the command.
Related show ip bgp dampened-paths
Commands

bgp default local-preference

Change the default local preference value for routes exchanged between internal BGP peers.
Z9500
Syntax
bgp default local-preference value
To return to the default value, use the no bgp default local-preference
command.
Border Gateway Protocol
half-life period expires. The range is 1 to 45. The default is 15
minutes.
(OPTIONAL) Enter a number as the reuse value, which is
compared to the flapping route's Penalty value. If the Penalty
value is less than the reuse value, the flapping route is once
again advertised (or no longer suppressed). The range is 1 to
20000. The default is 750.
(OPTIONAL) Enter a number as the suppress value, which is
compared to the flapping route's Penalty value. If the Penalty
value is greater than the suppress value, the flapping route is
no longer advertised (that is, it is suppressed). The range is 1
to 20000. The default is 2000.
(OPTIONAL) Enter the maximum number of minutes a route
can be suppressed. The default is four times the half-life
value. The range is 1 to 255. The default is 60 minutes.
(OPTIONAL) Enter the keywords route-map followed by the
name of a configured route map. Only match commands in
the configured route map are supported.
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
– views the BGP paths.
485