Dell Z9500 Reference Manual page 817

Parameters
interface {slot/
port | port} —
port}, interface
{slot/port |
port} — port},...
Defaults None
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
pre-Version
6.1.1.0
Interfaces
Enter interface range and one of the interfaces and then
slot/port, port-channel, or VLAN number information. Select
the range of interfaces for bulk configuration. You can enter
up to six comma-separated ranges. Spaces are not required
between the commas. The ranges can include VLANs, port-
channels, and physical interfaces.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a Tunnel interface, enter the keyword Tunnel then a
number from 1 to 16383.
Description
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Added support for 4093 VLANs on E-Series ExaScale. Prior
releases supported 2094.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
817