in
out
Command
EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
Z9500
Syntax
debug ip bgp [ vrf vrf-name | A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name
A.B.C.D
X:X:X:X::X
peer-group
peer-group-
name
in
Border Gateway Protocol
Enter the keyword in to re-configure soft inbound updates.
Enter the keyword out to re-configure soft outbound
updates.
Description
Added the ipv4 multicast and ipv6 unicast parameters.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the keyword vrf and then the name of the VRF to
debug BGP information corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol
operations corresponding to either a default or non-
default VRF.
Enter the IPv4 address of the neighbor in dotted decimal
format.
(OPTIONAL) Enter an IPv6 address.
Enter the keywords peer-group then the name of the peer
group to debug.
(OPTIONAL) Enter the keyword in to view only information
on inbound BGP routes.
371