Neighbor Send-Community; Neighbor Soft-Reconfiguration Inbound - Dell Z9500 Reference Manual

Usage
The first time you enter this command it configures the neighbor as a route
Information
reflector and members of the route-reflector cluster. Internal BGP (IBGP) speakers
do not need to be fully meshed if you configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route
reflector.

neighbor send-community

Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that
all routes with that attribute belong to the same community grouping.
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} send-community
To disable sending a COMMUNITY attribute, use the no neighbor {ipv6-
address | peer-group-name} send-community command.
Parameters
ipv6-address
peer-group-
name
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.4.1.0

neighbor soft-reconfiguration inbound

Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
Z9500
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
524
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of the peer group to send a COMMUNITY
attribute to all routers within the peer group.
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
Border Gateway Protocol